leads4pass 350-501 dumps contain 432 latest exam questions and answers, is the latest version in April 2023, is suitable for the Cisco SPCOR exam, and guarantees your exam success!
leads4pass 350-501 dumps come in both PDF and VCE study formats, they both contain the latest exam questions and answers. So, download 350-201 dumps: https://www.leads4pass.com/350-501.html,
Choose any format to help you practice for the exam to guarantee you a 100% pass on the Cisco SPCOR exam.
More importantly! Some of the leads4pass 350-501 dumps exam questions are provided for free: https://drive.google.com/file/d/1YRm3nBeLPCjhGQbbXJJj5dpiolg_0jj8/
Some of the leads4pass 350-501 dumps exam questions provide you with online practice tests
| From | Number of exam questions | Exam name | Exam code | Last shared |
| leads4pass | 15 | Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) | 350-501 | 350-501 dumps |
Question 1:
Refer to the exhibit.
Which statement is true about what this AS filter accomplishes?
A. It filters incoming BGP updates with any AS number starting with the digit 5 and ending with the digit 5, and this only in an AS_PATH.
B. It filters incoming BGP updates with any AS number matching “5.5”, but not 515,525.535, etc only in an AS_SET.
C. It filters incoming BGP updates with any AS number starting with the digit 5 and ending with the digit 5 and this only in an AS_SET.
D. It allows any number with the statement “.*” and this only in an AS_PATH.
Correct Answer: B
Question 2:
Refer to the exhibit.
In regard to the traffic that is flowing from CE1 in the direction of CE2, what is the label stack in the packets that are leaving R6?
A. {16}
B. {16 25}
C. {25}
D. {0 25}
Correct Answer: D
Question 3:
Refer to the exhibit.
An organization s network recently experienced several significant outages due to device failures. The network administrator just moved the network devices to a new central data center, and packets are switched using labels. The administrator Is now implementing NSF on the network to reduce potential risk factors in the event of another outage.
Which task must the administrator perform on each router as part of the process?
A. Remove route filtering to speed repopulation of the link-state database
B. Copy the router s existing state information and share the file with its peers to enable BGP soft resets
C. Implement MPLS to forward packets while the RIB updates after a failover.
D. Implement a Graceful Restart to mitigate the delay in MPLS LDP synchronization when the IGP starts up.
Correct Answer: D
Question 4:
DRAG DROP
Drag and drop the OSs from the left onto the correct descriptions on the right.
Select and Place:
Correct Answer:
Question 5:
A service provider requires continuous real-time network monitoring to provide reliable SLAs to its customers. To satisfy this requirement, a network administrator is implementing gRPC dial-out on an ASR with TLS. Receiver 192.168.10.2 will be assigned one of the subscriptions, and it will manage the ASR. Which configuration must the engineer apply to the router as part of the configuration process?
A. snmp-server community publicsnmp-server enable trapssnmp-server host 192.168.10.2 version 2c public.
B. telemetry model-driven
destination-group DGroup1
address-family ipv4 192.168.10.2 1 port 10
encoding self-describing-gpb
C. SNMP-server community publicsnmp-server enable trapssnmp-server enable traps snmp authentication SNMP-server manager SNMP-server manager session-timeout 1000
D. telemetry model-driven destination-group Cisco test
address-family ipv4 192.168.10.2 port 10
encoding self-describing-gpb
protocol grpc tis-hostname ciscotest.com
Correct Answer: D
Question 6:
A network engineer is configuring RIP as the routing protocol between multiple PEs and CEs. The engineer must avoid advertising the same routes back to their sources. Which action should be performed on the routers to accomplish this task?
A. Define the site of origin on each interface.
B. Configure a different route distinguisher for each prefix.
C. Define VRFs on each device to separate the traffic.
D. Enable bidirectional forwarding detection on each device.
Correct Answer: B
Question 7:
DRAG DROP
Drag and drop the LDP features from the left onto the correct usages on the right.
Select and Place:
Correct Answer:
Question 8:
Refer to the exhibit.
R2# configure terminalR2(config)# interface Ethernet1/0R2(config-if)# ip address 10.1.1.1 255.255.255.255
An engineer is configuring two routers to support MPLS LDP sessions between them. The R1 configuration is complete, and work has started on R2 as shown. Which additional configuration must the engineer apply to R2 to complete the task?
A. R2(config)# mpls label protocol ldp R2(config)# interface Ethernet1/0 R2(config-if)# mpls bgp forwarding
B. R2(config)# mpls label protocol ldp R2(config)# interface Ethernet1/1 R2(config-if)# ip vrf forwarding CISCO R2(config-if)# ip ospf network point-to-point
C. R2(config)# mpls ip R2(config)# mpls label protocol ldp R2(config)# interface Ethernet1/0 R2(config-if)# mpls ip
D. R2(config)# mpls label protocol ldp R2(config)# interface Ethernet1/0 R2(config-if)# ip vrf forwarding CISCO R2(config-if)# ip ospf 1 area 0
Correct Answer: C
Question 9:
Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?
A. The Internet gateway router is connected as a PE router to the MPLS backbone.
B. The CE router supports VRF-Lite and the full BGP routing table.
C. The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN.
D. The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway.
Correct Answer: D
Question 10:
Refer to the exhibit.
If RC is a stub router, which entry must be injected so that it will send traffic outside the OSPF domain?
A. more specific route
B. virtual link between RB and RC
C. sham link
D. default route
Correct Answer: D
Question 11:
A support engineer has been tasked to protect an ISP infrastructure from the growing number of encrypted DDoS attacks. The solution should also validate the eBGP peering. Which solution accomplishes these goals?
A. BGP FlowSpec
B. BTSH
C. BGP Route Dampening
D. BGP LS
E. RTBH
Correct Answer: B
Question 12:
Which two routing protocols support Cisco MPLS TE tunnels? (Choose two.)
A. RIP
B. EIGRP
C. BGP
D. IS-IS
E. OSPF
Correct Answer: DE
Question 13:
Which two uses of the YANG data modeling language are true? (Choose two.)
A. It can be used to model the configuration used by NETCONF operations.
B. It can be used to access a device by HTTP.
C. It can be used to replace the OSI model for troubleshooting.
D. It can be used to shape state data of network elements.
E. It can be used to replace RESTCONF as a mechanism to install and manipulate configuration.
Correct Answer: AD
The same document (1st page, 3rd paragraph) holds this line:
“YANG is primarily used to model the configuration and state data used by NETCONF operations.”
Question 14:
Refer to the exhibit.
Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 networks via BGP and advertise them into OSPF area 0. An engineer has noticed that the OSPF domain is receiving only the 172.17.1.0/24 route and default route 0.0.0.0/0 is still missing. Which configuration must an engineer apply to resolve the problem?
A. router ospf 1 redistribute bgp 65001 metric 100 route-policy BGP-TO-OSPF end
B. router ospf 1 default-information originate end
C. router ospf 1 default-metric 100 end
D. router ospf 1 default-information originate always end
Correct Answer: B
Question 15:
Refer to the exhibit.
The USER mat is connecting an application on an Internet connection in AS 100 is facing these issues:
1.
The USER lost the connection to the application during a failure Between IG and R2.
2.
Router R2 configuration a loss due to a power outage.
3.
The application the USER is connecting to a hosted behind CE2. What action resolves the issues on R3 and R4 routers?
A. Set R4 as a route reflector for R3 and CE2
B. Apply high Local Preference on R3 toward R1
C. Set R3 as a route reflector for R4 and CE1
D. Apply low Local Preference on R4 toward R2.
Correct Answer: D
…
Practice the latest 350-501 SPCOR exam questions online to verify your current study status!
More importantly! I can guarantee that using 350-501 dumps with PDF and VCE: https://www.leads4pass.com/350-501.html (432 Q&A) will help you pass the Cisco SPCOR exam easily.
